Skip to content
  • There are no suggestions because the search field is empty.

How to Clear the Memory of Connect Series Devices

This article provides step-by-step instructions for clearing the memory of Lightwave Connect Series dimmers, sockets, and relays. It helps users reset devices before re-pairing or when troubleshooting connectivity issues.

If you need to remove all previously linked devices or reset your Lightwave Connect Series devices, follow the steps below to clear their memory. This is useful when repurposing a device or troubleshooting pairing issues.


🔌 Clearing Memory on Relays and Sockets

  1. Press and hold the manual button for approximately 5 seconds until the LED blinks — this indicates the device is in learning mode.

  2. Release the button.

  3. Press and hold the manual button again for another 5 seconds until the LED begins to blink rapidly.

  4. Release the button.

  5. Quickly press (do not hold) the manual button while the LEDs are blinking rapidly.

  6. The relay or socket memory has now been cleared.


🔘 Clearing Memory on a Dimmer Switch

  1. Press and hold both buttons on the dimmer channel for around 5 seconds until the LED blinks blue and amber, indicating it is in learning mode.

  2. Release the buttons.

  3. Press and hold the OFF/Bottom button for approximately 5 seconds until the LEDs blink rapidly.

  4. Release the button.

  5. Quickly press (do not hold) the OFF/Bottom button while the LEDs are blinking rapidly.

  6. The dimmer switch memory has now been cleared.


💡 Tip: Always clear the memory of a Connect Series device before attempting to re-pair it to avoid connection issues.