How to pair a Connect Series device to the Lightwave Link Plus app.

Setting up your Lightwave Connect Series device using the Lightwave Link Plus app is just as simple as pairing a Smart Series device. Follow the steps below to connect your device in minutes.

✅ Step-by-Step Pairing Instructions

1. Open the Lightwave Link Plus App

2. Tap the Green Plus (+) Button
   Located at the centre of the home screen.

   

3. Select “Devices”
   From the available options.

   

4. Choose “Link Connect Series Device”

   
   

   1. Select Your Device Type
      Choose the correct category and device model you’re pairing.

      

5. Name Your Device
   Assign a custom name for easy identification within the app.

   

6. Tap “Next"

   

7. Put the Device into Learning Mode

   • Follow the instructions in the device’s installation manual to activate learning mode.

   • This typically involves pressing and holding a button until an LED or signal indicates it’s ready.

8. Tap “Link” in the App

   • When your device is in learning mode, tap “Link” to initiate the pairing process.

9. Confirmation

• The app will confirm once the device is successfully linked.

💡 Tip: Ensure the device is powered on and close to your Link Plus hub during the pairing process for best results.