CONNECT SERIES - Can I adjust the dimming range on a dimmer?
If your lights appear too dim, flicker, or turn off after a few seconds, adjusting the dimming range can often resolve the issue. This guide explains how to fine-tune your CONNECT Series dimmer for smoother and more stable lighting control.
This process lets you fine-tune how low (and high) your lights dim — especially useful if LEDs flicker or won’t dim properly.
🔧 Why You’d Do This
- Lights flicker at low levels
- Bulbs don’t turn on at low brightness
- Dimming feels too aggressive or uneven
- You want a smoother fade
🔁 Step-by-Step Instructions
1. Turn the Light On
Make sure the dimmer is switched on and the light is active.
2. Enter Dimming Setup Mode
- Press and hold the on/off (power) button
- Keep holding until the light or LED indicator signals setup mode (usually a flash or change)
👉 This puts the dimmer into adjustment mode.
3. Adjust the Minimum Brightness
- Use the dim up/down controls to set the lowest level:
- Increase it if lights flicker or cut out
- Decrease it if you want a deeper dim
💡 Aim for the lowest level where the light stays stable.
4. Confirm the Setting
- Press the power button again to save the setting
- The dimmer will exit setup mode
5. Test the Result
- Dim the lights normally
- Check for:
- Smooth transition
- No flickering
- Consistent brightness
✅ Tips for Best Results
- LED bulbs vary — some need a higher minimum level
- If issues persist, try:
- Different bulb brands
- Ensuring bulbs are dimmable and compatible
- Adjust in small increments rather than big jumps
⚠️ Common Mistakes
- Setting the minimum too low → causes flickering
- Not saving the setting properly
- Using non-dimmable bulbs