Dimmer ON state
Notes: Colour cannot be changed by user
Dimmer OFF state
Notes: Colour can be changed by user
Flashing Red and Blue
Dimmer is in pairing mode
Notes: Stays in this mode for approximately 10 seconds
Dimmer has successfully paired to the Link Plus
Dimmer memory is full, needs to be cleared - How to clear the memory
Notes: Happens when attempting to put dimmer into pairing mode
Flashing Red and lights dim to 20%
Too much load is connected to the circuit or the lamps are incompatible
Notes: Dim level lowers to prevent overheating, if no change is made to the lamps then the dimmer will continue doing this
Dimmer has received power
Notes: Solid green will turn to flashing green after 5 seconds if no buttons are pressed.
Auto calibration (dimmer finds optimum dimming range)
Notes: Returns to OFF state when completed.
Flashing Green and Red
Manual calibration (lower dim level adjustment)
Notes: Pressing the OFF button on dimmer when power is given will start manual calibration mode, holding both buttons will allow adjustment of upper dim level adjustment.
Flashing Green and Blue
Manual calibration (upper dim level adjustment)
Notes: Pressing the OFF button on dimmer when power is given will start manual calibration mode, holding both buttons will complete manual calibration.
Flashing Light Blue
Dimmer is updating its firmware
Notes: Has to be initiated from the app, takes approximately 3 minutes.
Static Red to Static Green and OFF
Dimmer is trying update its firmware but it is failing
Fix : Power off the mains from the consumer unit (circuit) and restart the dimmer.